![]() ![]() Add the last two stakes to the holes at the top of the PVC poleīecause of this pole’s smooth, wide design, the creator hasn’t had any issues with her resident raccoons being able to climb up to steal food.Slip the PVC pipe over the stakes & hammer the PVC into the ground.Use the mallet/sledgehammer and drive 3 of the stakes halfway into the ground in a triangular pattern just inside the mark you made with the PVC pipe.Use the edge of the PVC pipe to mark on the ground where the pole will be (and the pole circumference).Repeat, drilling two more holes for the second stake.Drill 2 holes on each side of the pipe, using a drill bit that is the same size as the stake.Cut the PVC pipe to your desired height.Five 36-inch iron stakes (found in the rebar section.).A 3-inch wide piece of electrical PVC conduit (as long as you want your pole to be.).This baffle is an easy solution that would work well with a 4×4″ post: One thing I would add to this design is a squirrel baffle. The full instructions are available here! A 4×4″ post is topped with a decorative cap, and hooks are drilled into the sides to hang your feeders. This decorative DIY bird feeder pole would be a welcome addition to any backyard. At the end of the video is a neat DIY feeder project, the peanut butter log. ![]() I would recommend using feeders that weigh less than 5 lbs. This feeder station is better for small feeders since the pole and cross-posts are thin. You can use the platform as a birdbath, a tray feeder, or a place to offer other treats! The design for this DIY Bird Feeding Pole incorporates a platform and cross-posts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |